How serious are fertility problems today? People don't want to give birth,can't afford it, and can't give birth that has become the "three mountains".
The problem of childbirth is related to the people's livelihood. Whether a country can prosper or not depends on the population. I saw a set of data a few days ago. The data shows that on January 1, 1990, 2,784 babies were born in Shanghai. Ten years later, on January 1, 2000, 1,148 babies were born in Shanghai. In 2010, the number became 380. , 2020 only 156 people, the decline in the birth rate is shocking. The three most critical reasons are: I don't want to give birth, I can't afford it, I can't give birth! The decline of the global population will bring a series of economic and social problems, among which the demand for Prestressed Concrete will also be affected.
What is Prestressed Concrete?
Prestressed Concrete is a kind of concrete component mainly used in construction engineering and bridge engineering.
To avoid premature cracks in reinforced concrete structures, make full use of high-strength steel bars and high-strength Concrete, and try to reduce the tensile stress generated by the components by applying external forces before the concrete structures or components are subject to the service load, even in a state of compressive stress. Concrete elements are below.
How Prestressed Concrete Works
The pre-compression stress is used to reduce or offset the tensile stress of Concrete caused by the load, to control the tensile stress of the structural components to a small range, even in a compressed state, to delay the appearance and development of concrete cracks, thereby improving the resistance of the components. Crack performance and stiffness.
Advantages of Prestressed Concrete
1. Good crack resistance and high rigidity. Due to the prestressing of the components, the appearance of cracks is significantly delayed. Under the action of the load, the components may not appear to crack, or the cracks may be delayed, so the stiffness of the components is improved, and the durability of the structure is increased.
2. Save materials and reduce self-weight. Because its structure must use high-strength materials, it can reduce the number of steel bars and the section size of components, save steel and Concrete, and reduce the self-weight of the structure, which has obvious advantages for large-span heavy-load structures.
3. It can reduce the vertical shear force and primary tensile stress of concrete beams. The curved reinforcement (bundle) of the prestressed concrete beam can reduce the vertical shear force near the support in the beam. Because of the existence of prestress on the concrete section, the principal tensile stress under the load is also reduced. This is beneficial to reduce the web thickness of the beam so that the self-weight of the prestressed concrete beam can be further reduced.
4. Improve the stability of compression components. When the compression member is relatively long and slender, it is easy to be bent after receiving a certain pressure, resulting in loss of stability and destruction. If prestressing is applied to the reinforced concrete column so that the longitudinally stressed steel bars are tensioned very tightly, not only the prestressed steel bars themselves are not easy to bend, but they also can help the surrounding Concrete to improve the ability to resist bending.
5. Improve the fatigue resistance of components. Because the rebar with strong prestress has relatively small changes in stress caused by loading or unloading during the use stage. It can improve fatigue strength, which is very beneficial for structures that bear dynamic loads.
6. Prestress can be used as a means of connecting structural components to promote the development of new systems and construction methods for large-span structures
Some requirements for prestressed steel bars:
(1) The strength should be high. The tensile stress of prestressed steel bars will cause various stress losses during the entire fabrication and use of components. The sum of these losses can sometimes reach more than 200N/mm² if the strength of the steel bar used is not high, the stress established during tension will even be lost.
(2) It must have good adhesion with Concrete. Especially in the pretensioning method, there must be a high bond self-anchoring strength between the prestressed steel bar and the Concrete. For some high-strength smooth steel wire, it is necessary to go through "scoring," "pressure wave," or "kink" so that it can form scored steel wire, corrugated steel wire, and kinked steel wire to increase the bonding force.
(3) There must be sufficient plasticity and good processing properties. The higher the strength of the steel, the lower its plasticity. When the plasticity of the steel bar is too low, especially under low temperature and impact loading conditions, a brittle fracture may occur. Good workability means that the welding performance is good. When the upsetting head anchor plate is used, the upsetting of the steel bar head does not affect the original mechanical properties, etc.
TRUNNANO is a concrete additives supplier with over 12 years experience in nano-building energy conservation and nanotechnology development. We accept payment via Credit Card, T/T, West Union and Paypal. Trunnano will ship the goods to customers overseas through FedEx, DHL, by air, or by sea.
If you are looking for high quality concrete additives, please feel free to contact us and send an inquiry.
Since the beginning of this year, China's macro policies have made continuous efforts to stabilize economic growth. America and Europe are raising interest rates to control inflation. On March the European Central Bank left its three key interest rates unchanged and began to scale back its asset-purchase programme. Then the Federal Reserve raised the target range of the federal funds rate by 25 basis points to 0.25%-0.5%. The accelerated tightening of monetary policies in the US and Europe pushed capital back to the US and increased interest rates, which will definitely increase the risk of RMB depreciation and capital outflow. The price and market of the Prestressed Concrete will also be affected, resulting in a range of fluctuations. You are welcome to contact us for the latest quotation of Prestressed Concrete.
Is boron amorphous or crystalline?Boron can be prepared in several crystalline and amorphous forms. The well-known forms of crystallization are α-rhombohedral (α-R), β-rhombohedral (β-R) and β-tetragonal (β-T). In spec…
What is copper oxide?Copper oxide is an inorganic substance. Copper oxide chemical formula is CuO. It is a black oxide of copper. Slightly bisexual and slightly hygroscopic. Insoluble in water and ethanol, easily soluble in acid, thermally stable, de…
Expandable graphite or exfoliated graphite is made from the naturally occurring mineral graphite. The layered structure of graphite allows molecules to be inserted between the graphite layers. By adding acid, graphite sulfate can usually be converted…